Shelving plug-in kit

Specification

<

Specification

Create a bookshelf with ease using our shelving plug-in kit solution, complete with wallbands, brackets, plugs and pre-plugged melamine shelves. The patented plug-in technology and the hole pattern in the wallbands makes installation easy. Detailed step-by-step assembly instructions are included in the kit.

Product LineSparring by Elfa

Article number

440025

ColorGraphite

Width (mm)780

Depth (mm)218

Height700

Technical description

<

Technical description

A grab-and-go kit solution that contains all you need to create a 3-shelf bookshelf solution. The kit is easy to install correctly, thanks to the plug-in technology and the hole pattern in the wallbands.

2 metal colours:
White, close to NCS S 0300-N, gloss around 85
“Graphite”, a unique finish close to NCS S 8000-N, gloss around 50
Note: as our finishes are metallic/mixed powder, the NCS codes/gloss aren’t exact.

Planning rules

<

Planning rules

Can be planned onto any space on an open wall. Be sure to plan the solution so that it doesn't create an obstacle when you are moving past it.

The kit includes all you need, except screw/plug hardware.

Possible to add book support.

Safety and care

<

Safety and care

Safety

Note! Do not place Elfa products in direct contact with water.

Care

Wipe clean with a cloth dampered with a mild cleaner. Wipe dry with a clean cloth.

Assembly Instructions

<

Assembly Instructions

Assembly instruction: Shelving system plug-in 700mm

Mounting instruction: Shelving system Plug-in

You need the following to assemble: Screwdriver/drilling machine, leveller.

Step 1: Position the first wallband. Make sure that the wallband is straight and mark the screw holes. Fasten the wallband in the upper screw hole, but do not tighten too hard.

Step 2: Rotate the wallband 90 degrees upward, using it as a “spacer”, to get the correct positioning for the other screw holes. In this way it’s very easy to get, and verify, a correct ‘square’ on the wall. Once you have secured that the wallbands are level, attach both wallbands to the wall with adequate screws.

Step 3-4: Place the pins into the bracket – the short pin for the front of the bracket and the longer pin for the rear part of the bracket. The “tower” on the pins should lean towards the back of the bracket. Turn the bracket and use a firm support in order to be able to attach the plug onto the pin. The “plate” of the pin should be level with the upper part of the bracket when assembled correctly.

Step 5: Attach the brackets. Make sure that the are placed in the corresponding slots. A tip is to place the brackets so they cover the screw holes in the wallband. Mount the shelves, so that they click onto the bracket pins.

Step 6: Your shelving solution is ready!

Assembly Instructions