Installation of LED lighting in hang standards: Step 1: Pull the lighting cables through the hang standards. Feed the connector ends through the correct slots where you plan to place your lighting (according to your layout plan). A branching lighting cable is connected to the cable from the light fitting. If you have more than one light, the other end is used to connect to an additional lighting cable. (Only one end goes through the slot.) Tip: Fold back the connector ends so that they do not fall back through the slots. Step 2: Turn the hang standard so that the back side is facing up. Use 3–4 cable organizers along the cable. The cable should lie in the centre grooves of the cable organizers. Step 3: Connect as many lighting link cables as needed to reach the bottom of the hang standard. At least 75–100 mm (3–4") should extend below the bottom of the hang standard. Step 4: Press down the clips on the back of the hang standard so that they are flush. Note: If you are using an extension standard, cables can be routed down in the same way. Step 5: Your lighting cable box should contain the transformer. Install it close to the wall socket or at the bottom of the hang standards. The transformer and power supply cable can lie loose in the cable box or be secured using the included double‑sided tape. Step 6: Install the lighting cable box next to the connector end of the lighting cable hanging out from the bottom of the hang standard. Connect the connectors. Note: Do not connect the power supply to the wall socket yet. Step 7: Attach the lid of the lighting cable box by pressing it onto the cable box. Installation of LED lighting under wall cabinets: LED light fittings are attached to the underside of the wall cabinets using strong magnets. Route the cable from the light fitting along the edge under the cabinet towards the back wall. Feed the cable end through the hole in the lower corner of the cabinet. Connect the connector end to the connector end of the lighting cable coming from the hang standard. If you have several cabinets next to each other, the light fittings can be connected in series. Place the lighting cables along the edges under the cabinets and route them through the holes to the next cabinet. Installation of LED lighting under wire shelf: Place the included mounting clip over the wire as shown in the illustration. Press until you hear a “click”. Route the lamp cable to the brackets and connect it to the lighting cable in the hang standard.