You need the following to assemble: metal saw (if you need to cut the wire shelf).

Before you start: Mount the brackets. If needed, cut the wire shelf to the desired width.

A wire shelf has a top and a bottom. The middle support wire is connected to the bottom of the shelf.

Step 1: Place the bottom of the wire shelf over the notches in the bracket.

Step 2: Install the shelf with end wires inside the brackets. Lock the shelf into place by pressing down on the middle of the shelf and pushing toward the wall.

Step 3 (if you have a gliding frame sharing the same bracket): Attach the 4 "C-clips" (included in the gliding frame packaging). Snap them over the two middle crosswires in the gap next to the outer wires on the wire shelf.

To reposition a wire shelf after it’s been attached to the brackets: hold by the brackets, and lift the front of the shelf toward the ceiling and outward to release the entire unit from the hang standards.

Demount: To remove a wire shelf from a bracket while on the hang standards: hold the hang standard steady with one hand. Place the other hand at the back of the shelf. Pull up and forward to release.

Tip: If you have gliding drawer frames or perhaps a work surface in your solution, assemble these before installing the wire shelves. This to ensure that the CC measurement is correct - making the installation of the wire shelves easier.