Mounting LED-lighting on standards:

Step 1: Run lighting cables through standards. Feed connector ends of the lighting cable through the correct slots for where your lights will be placed (according to
your space plan). One split of the lighting Cable will plug into the wire coming off your light. If you have more than one light, you will use the other end to connect to another
lighting cable. (Only one end will go through the slot.)

TIP: Fold connecter ends back so they don’t fall back through the slots.

Step 2: Turn the standard over so the back side is facing up. Use 3-4 cable organizers along cable. The cable should be in the middle slots of the cable organizers.

Step 3: Connect as many lighting cables as needed to reach the lower part of the standard. A minimum of 75-100 mm (3"-4") should hang outside the lower part of the standard.

Step 4: Push the clips down the back of the standard so they are flush. NOTE: If using an extension standard, cables can be ran down the back of the standard in the same way.

Step 5: Your lighting cable box holds your transformer. Mount it close to your wall outlet or at the bottom of the standards. The Transformer & power cord can be mounted loose in the lighting cable box or be secured with the included double-sided tape.

Step 6: Mount the lighting cable box next to the connector end of the lighting cable hanging out of the bottom of the standard. Connect the connectors to each other. NOTE: Do not plug the power cord into an electrical outlet at this time.

Step 7: Attach the cable box cover onto the lighting cable box.

Mounting LED-lighting under an upper cabinet:
LED Fixtures attach to the underside of the upper cabinets with strong magnets. Run the cable coming from the lighting fixture back along the ledge under the cabinet toward the back wall. Poke the end of the lighting fixture cable through the hole in the lower corner of the cabinet. Connect the connector end to the connector end of the lighting cable coming from the Standard. If you have cabinets mounted next to each other, lighting fixtures can be connected one to another, daisy-chain style. Position lighting cables along the ledges under the cabinets and pull lighting cables through the holes to the next Cabinet.

Mounting LED-lighting under a wire shelf:
Position the included mounting clip over the wire as shown. Press into place until you hear a “click.” Pull light fixture cables over to brackets and connect to lighting cable in standard.