You need the following for installation: Screwdriver, ladder/step stool, and metal saw (if you need to cut the hang standard or extension standard). Important notice: If you are combining a hang standard and an extension standard, do not cut the hang standard. Only cut the extension standard (from the bottom). Step 1: Hang the hang standard onto the lower “lip” of the top track. To fit the hang standard into the top track, aim for an entry point where there is a cut-out in the upper lip of the top track. Step 2: Once all hang standards are hung, group them together and install brackets in the selected positions. This is a good tip to ensure the brackets are aligned. Step 3: Slide the hang standards to their approximate positions on the top track. With the end stops at the outer edges of the top track, the hang standards can be positioned all the way out. Tip: If you have chosen a top track cover for your solution—and only have B:60 as section width in your solution—this is a good time to click these onto the top track to help achieve the correct spacing between hang standards. Step 4 (optional): If you want to secure the hang standards to the wall with a screw, do this after all functions in the system have been installed to ensure correct positioning of the hang standards. It is not necessary to fasten the hang standards to the wall; the system will stay in place when loaded. This is an optional step to stabilise the storage solution further against the wall. Use only one of the screw holes in the hang standard; there is no need to use all of them when securing to the wall. When combining a hang standard with an extension standard and adapter, only the centre screw hole on the hang standard may be used to fasten it to the wall (the lower hole is used for the adapter).