You need the following to assemble: metal saw (if you need to cut the wire shelf basket). Before you start: Mount the brackets. If needed, cut the wire shelf basket to the desired width. Mounting the wire shelf basket: Step 1: With the double wire front lip of the wire shelf basket facing forward, place the wire shelf basket wires over the bracket click in notches. Install the wire shelf basket with the end wires inside the bracket. Step 2: Lock the shelf into place by pressing down on the middle of the shelf and pushing toward the wall. Demount: To remove a wire shelf basket from a bracket while on the hang standards: hold the hang standard steady with one hand. Place the other hand at the back of the wire shelf basket. Pull up and forward to release. Mounting the wire shelf basket divider: Step 1: Determine the position where you want to place the divider. On the upper part of the wire shelf basket divider, you can identify which part is back vs. front. On the back, the divider is slightly sunk - on the front part, there is a small ledge.  Insert the back part of the divider, in between two wires and under the back double-wire. Step 2: Grab the front part of the wire shelf basket and pull it gently towards you, in order to create more space for the divider to slide in. Then snap the front part into place. Tip: If you have gliding drawer frames, gliding shoe shelf or an angled shelf in your solution, assemble these before installing the wire shelf basket. This to ensure that the CC measurement is correct - making the installation of the wire shelves easier.