Freestanding upright 2124 mm white

You need the following to assemble: Mallet.

Start by mounting the feet. 
* Foot for freestanding upright: Screw into the freestanding upright.
* Foot height extender: Attach the extender piece to the freestanding upright first and then screw the foot into the foot height extender. You can choose the desired solution height, depending on how deep you screw the foot into the foot height extender.

(A) Assembling a single-sided solution:

Step 1: Insert the freestanding uprights into the feet. The bottom of the upright is the part with the small holes on the side of the upright.
Using a mallet, press down and knock the upright into the slot of the foot. Make sure the upright goes all the way down.
Repeat the process with the second foot/upright.

Step 2: Place the two pieces on the floor and insert the cross-braces in an “X” – using the holes on the sides of the uprights.
Turn up the upright pieces, using one hand – where the other fixates the cross-braces. Then stand the unit upright.

Step 3: Place the unit towards the wall – no more than 75 mm from the wall. Secure the thicker stabilization bar between the uprights, using the mallet, ensuring they are completely into place. Alternate tapping the left and the right hand side.

(B) When adding an additional section: 

Repeat the process with feet and upright – and then place the additional upright with the front of the feet facing the current section.

Step 1: Attach the cross-braces in the hole.

Step 2-3: Twist out the added upright so that the cross-braces lock.
Place the end caps (and center caps if you have more than one section) on top of the uprights.

If you are adding a wire shelf at the bottom (on top of the foot), use the special designed clips to attach the shelf on front and back.

Make sure to finetune the height of the feet (with the included wrench) in order to have your system level.

(C) Assembling a double-sided solution:

Step 1: Assemble the foot to the upright (in the same way like for a single-sided solution)
Then slide in and mount the “backside” foot with a leveller.

Step 2: Repeat with the second upright.

Step 3: Attach the cross-braces in an “X”, with the upright sections placed as a “T”. Then twist to make the two uprights/feet parallel.