Crossbars | Elfa

Specification

<

Specification

Create a sturdy and dependable drawer unit by connecting frame sides with our crossbars. Designed to work with drawers in corresponding width. Includes 2 top- and 2 base crossbars.

Product LineClassic by Elfa

Article number

204014

ColorWhite

Width (mm)450

Depth (mm)20

Height44

Technical description

<

Technical description

The bar that connects two frame sides into a drawer unit. Come in a pack with 2 top- and 2 base bars.

The crossbars determine the total width of the entire drawer unit. There are three widths: 35 cm, 45 cm and 55 cm.

There are two different sets of crossbars: the basic set of crossbars, which is used in all frame unit versions and the extension kit, which is used when combining frames on top of each other.

The same crossbars are used for both frame side depths (“standard” and “mini”).

2 metal colours:
White, close to NCS S 0300-N, gloss around 85
“Graphite”, a unique finish close to NCS S 8000-N, gloss around 50
Note: as our finishes are metallic/mixed powder, the NCS codes/gloss aren’t exact.

Planning rules

<

Planning rules

Planning drawer system unit depths:
Standard depth is 535 mm
Mini depth is 435 mm

Planning drawer system unit heights (height without frame feet, adjustable feet or casters):
4-runner: 440 mm
7-runner: 740 mm
10-runner: 1040 mm

When stacking drawer system units on top of each other, 30 mm is subtracted from the total height. For example:

440 mm + 440 mm = 880 mm – 30 mm = 850 mm.

Adding frame feet increases the total height by 2 mm.

Adding casters increases the total height by 77 mm.

Adding adjustable frame feet increases the total height by 50-63 mm.

Width:
The following drawers and crossbars are available for drawer system units – Standard and Mini:
W: 35
W: 45
W: 55

Safety and care

<

Safety and care

Safety

Note! Do not place Elfa products in direct contact with water.

Care

Wipe clean with a cloth dampered with a mild cleaner. Wipe dry with a clean cloth.

Assembly Instructions

<

Assembly Instructions

You need the following to assemble: rubber hammer/mallet and something to protect the floor (carpet, piece of cardboard etc.). If you don’t have a rubber hammer/mallet, you can use a hammer with a wood block to protect the frame.

Before you start: Make sure to secure that you are working on a non-sensitive surface – for example on a carpet or use a wood block or a piece of cardboard under the frames to protect the floor when hammering.

Step 1: Start by turning the frame sides upside down and lining them up next to eachother. Secure that the “runners” (A), the U-shaped channels on the inside of the frames, are pointing inwards.
Step 2: Fasten the crossbars with “double teeth” (B) to the frame side, using the rubber hammer/mallet. The Elfa Logo on the crossbars will read upside down in this position.
Step 3: Turn the structure again.
Step 4: Fasten the remaining crossbars with the “single tooth” and a flat top (C).

When finished, attach casters or frame feet onto the bottom teeth.

When mounting a drawer system on top of another drawer system, use the crossbar extension set (see separate assembly instruction under ""Extension kit"").

Assembly Instructions

Crossbar W: 45 white

43,58

Needs To Have

Wire drawer W: 45 D: 54 H: 18 white

Mesh drawer W: 45 D: 54 H: 18 white

4 runner frame sides D: 54 white

7 runner frame sides D: 54 white

10 runner frame sides D: 54 white