Elevate your closet organization with the Garage+ closet rod, crafted from pre-painted steel that matches seamlessly. Hang your clothes for a wrinkle-free and organized look, creating an efficient overview and easy access. Mount effortlessly into a closet rod holder and customize the width by cutting. Complete the setup with closet rod end caps for a polished finish.

Rod for hanging clothes, creating a good overview and easy access. Supplement with closet rod holder. Can be cut to desired widths. Add closet rod end caps to both ends for the finishing touch.

The closet rod is made from pre-painted steel.

Closet rod to be attached to closet rod holders and the ends covered with end caps in poly propylene-plastic.

Closet Rods can be made to measure and cut with a saw.
  
Colour:
Matte Grey (polyester colour) NCS S 7500-N, fine texture, gloss 5

When planning in Elfa Planner, the design tool has a choice where you can choose a solution with wire shelf with a closet rod underneath. The tool will automatically add closet rod holders when planning such a solution.

* Do not use a closet rod of more than 905 mm width (W:90) without adding a supporting closet rod holder in the center.
* If you are planning a solution with sliding doors, be sure to leave sufficient space between the interior and the sliding doors, to have space for the hanging clothes. In a system based on D: 40 / 16", we recommend at least 550 mm measured from the back wall to the sliding doors.

Choose as long of a closet rod as possible. 

When joining closet rods, each closet rod will need to be cut down by 10 mm / 3/8”.

If a closet rod is positioned in a mid section, it needs to be cut down by 18 mm/ 6/8” to be able to be joined inside the closet rod holders. 
Note: if the outer Closet Rods aren't  cut, there will be an outstick (unless rods are cut 10 mm).

Assembly Instructions