Top track 1248 mm Matte grey

The top track is the foundation of the system and attaches to the wall horizontally. Top tracks are made from high strength steel and are attached to the wall with screws and/or screws and anchors. 

There are two ""lips"" on the top track  onto which the standards attach. These two attachment points prevent standards to move out of the track. There is also a safety function - ""end stops"" - in either end of the top track, preventing hang standards to move out sideways. 

The weight of a loaded system pulls the standards down securely onto the top track, and presses them back against the supporting wall, increasing stability and durability at the same time.

The bore holes in the top track are oval - width 20 mm (6/8”) and height 7,2 mm (2/8”) for easier positioning towards studs etc. 

Use a top track cover to cover the screw holes in the top track. 

Colour:
Matte Grey (polyester colour) NCS S 7500-N, fine texture, gloss 5

The minimum placement (measured from the underside of the top track) from the ceiling is 57 mm, to ensure that there is sufficient space to be able to hang in hang standards. 

In order to have the right placement of the system, if you intend to have cabinets and a workbench - the recommended placement of the top track is 2401 mm from the floor (measured from floor to the center of the screw holes in the top track). 

The widths of the top tracks are designed to fit with standard section widths. Top Tracks are, however, able to be cut when designing a section which differs from the standard widths. Recommendation is to cut the joining top track on the left side in order to keep the end stop at the outer edges of the track. 

When cutting a top track; make sure to make the cut a minimum 3 mm from a bore hole or cut out on the upper side of the top track.

Maximum load per section is 240 kg. Do not store too much on each interior product and distribute the weight evenly across the system. Ensure the material and condition of the wall.

We recommended that the top track should be fastened to the wall with a screw in all holes in the top track.

Assembly Instructions