You need the following to install: Drilling machine with a 2 mm drill bit, screwdriver with PH2 drill bit.

Before you start: Ensure that the front edge of the drawer is no closer than 50mm from the front edge of the cabinet.

Step 1: Position the drawer and base in your cabinet in the desired location, allowing clearance for the cabinet door to close.

Step 2: Remove the gliding part from the base and place on a flat surface. Mark the location of the holes in the base inside the cabinet. Drill a "pilot hole" (1-2 mm hole to prevent damaging the material when fastening the screws) at each marked location. With a screwdriver, secure the base inside your cabinet using the included screws.

Step 3: Attach one clip at each corner of the gliding part. Align the drawer over the clips and use the included screws to attach the drawer to the gliding part.

Step 4: Insert the drawer and glider into the base mounted inside your cabinet.