Wire shelf W: 90 D: 30 Graphite

You need the following to assemble: metal saw (if you need to cut the wire shelf).

Before you start: Mount the brackets. If needed, cut the wire shelf to the desired width.

A wire shelf has a top and a bottom. The middle support wire (A) is connected to the bottom of the shelf.

Step 1: Place the bottom of the wire shelf over the notches in the click-in bracket. 

Step 2: Install the wire shelf with end wires inside the brackets. Lock the shelf into place by pressing down on the middle of the shelf and pushing toward the wall. 

To reposition a wire shelf after it’s been attached to the brackets: hold by the brackets, and lift the front of the shelf toward the ceiling and outward to release the entire unit from the hang standards. 

Demount: To remove a wire shelf from a bracket while on the hang standards: hold the hang standard steady with one hand. Place the other hand at the back of the shelf. Pull up and forward to release.

Tip: If you have gliding drawer frames, gliding shoe shelf or an angled shelf in your solution, assemble these before installing the wire shelves. This to ensure that the CC measurement is correct - making the installation of the wire shelves easier.